Flymo Minitrim ST Original Instructions Manual
Flymo Minitrim ST Original Instructions Manual

Flymo Minitrim ST Original Instructions Manual

Hide thumbs Also See for Minitrim ST:

Advertisement

Quick Links

Minitrim ST
®
Minitrim Auto ST
Minitrim Auto XT
Original Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Minitrim ST and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Flymo Minitrim ST

  • Page 1 Minitrim ST ® Minitrim Auto ST Minitrim Auto XT Original Instructions...
  • Page 2: Carton Contents

    Carton Contents Mini Trim ST Mini Trim Auto XT Mini Trim Auto ST Switch Lever Switch Lever Safety Lock-off Lever Safety Lock-off Lever Upper Shaft Upper Shaft Electric Cable with Electric Cable with moulded on plug moulded on plug Lower Instruction Lower Shaft...
  • Page 3 there are signs of damage or ageing. 5. Do not walk backwards when trimming, you could trip. 3. Do not use the trimmer if the electric cables are dam- Walk never run. aged or worn. 6. Keep cutting head below waist level. 4.
  • Page 4: Starting And Stopping

    Assembly Instructions Shaft Assembly (A) 1. Locate the lower shaft (A1) into the upper shaft (A2). 2. Grasp firmly and hold steady the lower shaft. Locate the upper shaft and snap together firmly. • The unit is correctly assembled when the gap be- tween the upper and lower shaft has been closed.
  • Page 5: Manual Line Feed System

    Using the Plant & Tree Guard (Minitrim Auto XT only) The Plant and Tree Guard (J1) allows the trimming of grass close to plants and trees without damaging them with the cutting line. 1. Flip the guard down as illustrated in Fig G. 2.
  • Page 6: Automatic Line Feed System

    To replace nylon line on spool 1. Take approximately 5 metres of line line and insert into one of the line lock holes in the spool (M). 2. Wind line onto spool in the direction of the arrows on the top of the spool. Care should be taken to ensure that the line is neatly coiled on the spool (M).
  • Page 7: Replacement Parts

    To fit spool and line complete: 1. Remove old spool. 2. Place new spool into spoolholder with cut out areas of the spool in line with eyelets as shown in figure R. Cut out area 3. Release one line from cleat and feed line through eyelet (R). of spool 4.
  • Page 8: Maintenance

    Maintenance After you have finished using your trimmer follow the pro- cedure below: 1. Disconnect from the mains electricity supply. 2. Never clean your trimmer with water, cleaning fluids, or solvents, just remove debris with a suitable tool, a soft brush or dry cloth.
  • Page 9: Ec Declaration Of Conformity

    Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. Copyright © 2008 Flymo S.A. All rights reserved. Flymo® and other product and feature names are registered or unregistered trademarks of Flymo S.A.

This manual is also suitable for:

Minitrim auto xtMinitrim auto st

Table of Contents