Creating System Software Backup Diskettes; Setting Up In A Macintosh Environment; Installing And Configuring Services For Macintosh - Intergraph InterServe 75 Start Here Manual

available on the operating system CD-ROM. You may need these backup diskettes later -- for
example, if you have to reinstall a device driver or the operating system.
NOTE You may not have to create backup diskettes for all system software. If Version Manager
does not list drivers or other system software products, then they are available on the
operating system software CD, or on backup diskettes delivered with expansion boards.
If the system requires Quick-Fix Engineering (QFE) update software, it is included in the
system software available for backup diskette creation. QFE update software contains fixes
for operating system problems or limitations, and is only shipped with the system if it is
needed. If QFE update software is shipped with the system, you should create a QFE backup
diskette for use if you have to reinstall the operating system.
See Version Manager Help for information on creating system software backup diskettes.
Visit the Intergraph Computer Systems site on the World Wide Web and vendor bulletin
boards for new and updated drivers.

Setting Up in a Macintosh Environment

You may be using your InterServe 75 in a publishing and prepress environment with
Macintosh systems. If so, take the following steps to set up the system for use with these
Macintosh systems.

Installing and Configuring Services for Macintosh

The following procedure describes how to set up Windows NT Services for Macintosh on a
network that does not require Appletalk routing.
To install and configure Windows NT Services for Macintosh:
1. Insert the Windows NT CD-ROM into the system's CD-ROM drive.
2. Go to Start/Settings/Control Panel/Network/Services (tab).
3. Click Add. The Select Network Services dialog displays.
4. Click Services for Macintosh, and then click OK. Windows NT installs Services for
Macintosh and lists the service on the Services tab.
5. Configure the zone information as appropriate for your network. If your network requires
Appletalk routing, refer to your Windows NT Server documentation.
6. Click Close.
7. When prompted, restart the system for these changes to take effect.
7