Intergraph InterServe 75 Start Here Manual page 12

4
If the system is connected to a network, get and record the following information from your
network administrator:
u
Computer name for your system:
u
Workgroup name (if the system will be
part of a workgroup):
u
Domain name (if the system will be part
of a Windows NT domain):
u
Security role for your system in the
Windows NT domain -- primary domain
controller, backup domain controller, or
stand-alone server:
u
If your system will be acting as a backup
domain controller or stand-alone server,
username and password of an authorized
domain administrator account:
NOTE Determine the security role for your server before beginning system configuration. You cannot
change a stand-alone server to a domain controller without reinstalling Windows NT Server.
A domain controller maintains security policy and performs user authentication for a domain.
Stand-alone servers may be part of a domain, although they do not have to participate in a
domain. Refer to the operating system documentation for a detailed explanation of the
differences between domain controllers and stand-alone servers.
NOTE On a system with Windows NT Small Business Server, the system becomes a domain
controller by default.
If the system is connected to a network that uses the Transmission Control Protocol/Internet
Protocol (TCP/IP), obtain and record the following TCP/IP networking information from
your network administrator:
u
Internet Protocol (IP) address for your
system:
u
IP subnet mask for your system:
u
IP domain name for your network:
u
IP address for your network's default
gateway:
u
IP addresses for your network's
Domain Name System (DNS) servers,
if any: