Intergraph ErgoView Stand Installation Manual page 20

16
For a Hamilton base, connect the AC adapter cable (MCBLT73) to the existing Hamilton base
power cord.
NOTE The base power cord is permanently attached to the Hamilton base.
2. Remove the AC receptacle cover from the ErgoView stand as shown in the following figure.
Connect the power cord (or AC adapter cable) to the AC receptacle.
3. If installing a single ErgoView stand, attach the interconnect jumper into the standalone safety
jumper. Do not install the interconnect jumper for dual stands.
Interconnect
Jumper
Power Cord
(or AC Adapter
Cable)
To table
base
CAUTION When connecting cables from a digitizing table base to the ErgoView stand, always use the AC
receptacle on the front of the ErgoView stand. This will ensure power shutdown to the table base in
case of an obstruction.
AC Adapter
Cable
AC Receptacle
Cover
Base
Power
Cord