ZyXEL Communications U-1496 series User Manual page 77

+<command>=<value> Execute a command or set a parameter
+<command>? Read possible settings
+<command>=?
Supported Commands (per EIA PN2388 8/20/90)
+FAA=n
n=0
n=1
+FCLASS=n
n=0
n=2
n=6
n=8
+FBOR=n
n=0
n=1
+FICG="string"
+FCON DCE response, Fax connection made
+FCR=n
n=0
+FDCC=vr,br,wd,ln,df,ec,bf,st DCE capabilities parameters
vr=0
vr=1
br=0
br=1
br=2
br=3
br=4
br=5
wd=0
wd=1
wd=2
ln=0
ln=1
ln=2
df=0
df=1
ec=0
bf=0
st=0
st=1
st=2
st=3
st=4
st=5
st=6
st=7
+FDCS=vr,br,wd,ln,df,ec,bf,st
+FDIS=vr,br,wd,ln,df,ec,bf,st
command
+FDR Receive phase C data command; initiates document reception
+FDT=df,vr,wd,in
with negotiation
Read current setting
Auto answer mode parameter
DCE to answer as set by +FCLASS
DCE can answer and auto. determine calling type
Service class selection
Set to modem mode
Set to Class 2 mode
Set to ZFAX mode
Set to Voice mode
Phase C data bit order
Select direct bit order
Select reversed bit order in receiving mode
Local fax station ID string, for polling Rx.
Capability to receive parameter
DCE will not receive message data or poll a remote
Vertical resolution: Normal; 98 lpi
Vertical resolution: Fine; 196 lpi
Bit rate: 2400 bit/s; V.27ter
Bit rate: 4800 bit/s; V.27ter
Bit rate: 7200 bit/s; V.29 or V.17
Bit rate: 9600 bit/s; V.29 or V.17
Bit rate: 12000 bit/s; V.17
Bit rate: 14400 bit/s; V.17
Page Width: 1728 pixels in 215mm
Page Width: 2048 pixels in 255mm
Page Width: 2432 pixels in 303mm
Page length: A4; 297mm
Page length: B4; 364mm
Page length: unlimited length
Data compression format: 1-D; modified Huffman
Data compression format: 2-D; modified Read
Error correction disabled
Disable Binary file transfer
Minimum scan time/line 0 ms
Minimum scan time/line 5 ms
10 ms (normal); 5 ms (fine)
Minimum scan time/line 10ms
20 ms (normal); 10ms (fine)
Minimum scan time/line 20ms
40 ms (normal); 20ms (fine)
Minimum scan time/line 40ms
Current session parameter; refer to +FDCC command
Current session negotiation parameter; refer to +FDCC
Transmit phase C data command; releases the DCE to proceed