ZyXEL Communications U-1496 series User Manual page 48

control connection is made, used with ATV0 (S23b6), see result code table.
(6)
issued and profile 0 in the EEPROM has this bit set, supervisory password will be requested.
(5)
(4)
switch is pressed, modem will dial the default number. (See *Dn, S29).
(3)
(See *Pn, S17b1, S49b0).
(2)
(1)
(0)
Note: Available with cellular mode, otherwise this feature is reserved.
S36 Bit-mapped register, default = 000
Security function control
*Gn (7,6,5) =0;
remote site enters the call-back number.
Note: * In security type 1, the remote site must be a ZyXEL modem. In security type 2, the
remote site can be any other modem.
Remote configuration control
*Wab (1)
*Rab
*Fn (0)
S37 Bit-mapped register, default = 000. For remote configuration using panel menu control.
(See *Wab, *Rab)
(7,6,5,4)
(3,2,1,0)
Note: When using U-1496 panel for remote configuration, set S36 bit 1
and S37 first, then activate it in DIAGNOSTIC menu.
S38 Bit-mapped register, default = 000
(7,6)
(5)
(4)
FAX call is received..
(3)
connect message is sent. CD Off after last DCE response is sent. (UNIX system needs CD On
to enable serial port receiving.) (See &C1, S21b4.)
(2,1)
(0)
(See *Dn, S29)
=1; Enable password protection to profile saving. When AT&W0 is
=1; Enable Selective Reject in V.42
=1; Effective only on the U-1496E and U-1496R. When Data/Voice
=1; Add 12dBm attenuation to the leased line transmission power.
=1; V.26bis alternative A.
=1; Disable aborting from terminal during modem handshaking.
=1;* Use CELL 4800T trellis coded 4800 for V.32 4800.
Disable security function
=1; Enable type 1* security, with password check.
=2; Enable type 1 security, with password check and call back.
=3; Enable type 2* security, with password check.
=4; Enable type 2 security, with password check and call back.
=5; Enable type 2 security, with password check and call back,
=0; Write from local profile to remote profile.
=1; Read from remote profile to local profile.
=0; Deny remote request for configuration.
=1; Grant remote request for configuration.
=0-5; Local profile number.
=0-5; Remote profile number.
Reserved.
=1; Disable MNP5 negotiation regardless of error control setting.
=1; Disable FAX answering in MULTI-AUTO mode. Hang up if a
=0; CD tracks carrier.
=1; CD on/off sequence follows UNIX standard, CD On before
Reserved.
=1; Enable repeat dialing of the default number if not connected.