ZyXEL Communications U-1496 series User Manual page 58

Note: These commands *Hn and *HS need supervisory password checking. Any character can
be entered in the password (0-255). Maximum password length is eight.
+ *I0 AT command set (Default).
*I1 V.25bis command set.
*I2 Dumb mode.
Note: Enter RST command in V.25bis mode will revert modem to asynchronous AT command
mode.
+ *L0 Panel key normal (Default).
*L1 Panel key locked.
+ *M0 Leased line auto-handshake on originate mode (Default).
*M1 Leased line auto-handshake on answer mode.
*P0-15 Set leased line transmission power level, range from 0 dBm to -15dBm (Default
= -9dBm). Range from -12dBm to -27dBm if S35 bit 3 is set.
*Q0 No response to poor signal quality.
*Q1 Retrain action taken if signal quality is poor.
+ *Q2 Adaptive rate; auto fall-back or fall-forward (Default).
*Q3 Disconnect for poor signal quality.
*Rab Read remote profile b to local profile a.
a=
b=
Note: The command *Rab only works when modem is on-line, no matter what kind of connection.
+ *S0 Secondary channel disabled (Default).
*S1 Secondary channel enabled.
*T Display last caller ID message.
*V View password table.
Note: The command *V needs supervisory password checking.
*Wab Write local configuration profile a to remote user profile b and reset remote modem
from that profile.
a= 0-3,
4,
5,
b= 0-3,
Note: The command *Wab only works when modem is on-line, no matter what kind of
connection.
0-3, local user profile number.
0-3, remote user profile number.
4, remote active configuration.
5, remote factory default.
local user profile number.
local active configuration.
local factory default settings.
remote user profile number.