Flame Ignition - Teledyne 4030 Series Instruction Manual

4.2.4 Fuel
1. Open the main valve on the tank and set the fuel tank
pressure regulator to 30 psig.
3. Adjust the Fuel regulator until its pressure gauge reads the
recommended pressure of 3.5 psig.
Note: Adjust fuel settings only when the red LED (flame failure
light) is off.
TELEDYNE ANALYTICAL INSTRUMENTS
SPAN GAS
BYPASS FLOW
Figure 4-1: Front Panel View of Regulator and Gages

4.3 Flame Ignition

Observe that after warm up count down timer reaches zero (timer to
preheat the sensor), the amber heater lamp is blinking (indicating that
Teledyne Analytical Instruments
SPAN SAMPLE
TEMP. GAUGE
Operation
28