Teledyne 3010TB Operating Instructions Manual page 61

Oxygen Analyzer
•
CAUTION: Check the position of the Voltage Selector switch
•
•
•
•
115V
Figure 1-2: Electrical Connector/Control Panel
Power In Power input terminals for electric heater.
Requires 115 or 230 V ac, depending on
position of the Voltage Selector switch. Use
50/60 Hz.
BEFORE applying power to the Power Input termi-
nals.
Voltage Selector Power input selector switch for electric
heater. Adjusts input requirement for 115 or
230 V ac, depending on available source
voltage. Use 50/60 Hz.
Fuses 1.6 A, 250 V, T type, European size
5 × 20 mm fuses. Fuse 1 is on the neutral
side of the line. Fuse 2 is on the hot side of
the line.
Solenoid Valves Terminals that provide all electrical intercon-
nections from the Control Unit to the gas
control valves.
Sensor Signal Terminals that provide connections from the
Micro-Fuel Cell sensor to the Control Unit.
Teledyne Analytical Instruments
Part II: Analysis Unit
Part II: 1-3