Fitness Quest Edge 386da Owner's Manual page 6

ASSEMBLY
FIGURE 3
Step 5. Slide PEDAL BUSHING (8) onto
SHAFTS of PEDALS (9 RIGHT and
10 LEFT) as shown.
Step 6. Thread SHAFTS of PEDALS (9 & 10)
into CRANK (11) until tight, then back
off 1/2 turn.
Step 7. Thread PEDAL LOCK NUT (12) onto
end of SHAFT. Hold SHAFT with
(additional wrench) and tighten
PEDAL LOCK NUT with other wrench
until tight.
NOTE: PEDAL BUSHING (8) must be able
to spin freely after tightening.
NUT
15
LOCKING
KNOB
PULL
9
RIGHT
PEDAL
13
SEAT
FIGURE 4
Step 8. Turn LOCKING KNOB (15)
Step 9. Pull LOCKING KNOB (15) out and raise
WASHER
14
SEAT
POST
Step 10. Remove NUTS and WASHERS from
FIGURE 4
6
8
PEDAL
BUSHING
FIGURE 3
counterclockwise to loosen.
SEAT POST (14) to desired SEAT (13)
height and release LOCKING KNOB so
that it snaps into hole in SEAT POST
then turn clockwise until tight.
IMPORTANT
LOCKING KNOB MUST be locked tightly
before you sit on the SEAT.
SEAT (13) and attach SEAT to SEAT
POST (14) with NUTS and WASHERS.
11
CRANK
12
PEDAL
SHAFT
LOCK NUT