Section 9: Operation; Start-Up Sequence With Honeywell; Lighting Instructions; To Turn Off Gas To Appliance - Montigo DelRay Tuscany 34DVI Installation & Maintenance Manual

Honeywell
Blank
For Your Safety - READ BEFORE LIGHTING:
Flammable materials Explosion risk
WArnInG
General Warning If you do not follow these instructions exactly, a fire or explosion may result causing property Laser Radiation
damage , personal injury or death.
A. This appliance has a pilot which must be lighted by hand. Irritant Slippery floor
When lighting the pilot, follow these instructions exactly.
B. BeFore lIgHtIng smell all around the appliance area for
Gas bottles Watch for
falling objects
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
Low temperature Strong magnetic field
What to Do If You smell gas:
 Do not try to light any appliance.
 Do not touch any electrical switch; do not use any phone
in your building.
 Immediately call your gas supplier from a neighbour's
1. stoP! Read the safety information above on this label.
2. Flip down the door on the bottom of the faceplate.
3. Push in gas control knob and turn clockwise
4. Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas, stoP! Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5. Locate pilot burner and follow steps below.
6. Turn knob on gas control counterclockwise
LOT."
1. Turn off remote switch.
2. Flip down the door on the bootom of the faceplate.
P/N XG0515
Operation
Toxic Corrosive Danger overhead crane Fork lift trucks High voltage
Biohazard Oxidising Hot surface Danger of entrapment Danger of death
Watch your step Cutting High temperatures Glass hazard Danger of suffocation
Electricity Danger for cutter Entrapment hazard Battery hazard Rotating parts
Optical radiation Non ionizing Radiation Hazardous to the Danger of harming
radiation Environment your hands

Lighting Instructions:

to "OFF."
to "PI-
note: Gas control knob cannot be turned from
"PILOT" to "OFF" unless knob is pushed
in slightly. Do not force.

To Turn Off Gas To Appliance:

phone. Follow the gas supplier's instructions.
 If you cannot reach your gas supplier, call the Fire De-
partment.
c. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
7. Push in gas control knob completely and hold. Light with
Piezo Igniter button. Continue to hold the control knob in for
about (1) minute after the pilot is lit. Release the knob and it
will pop back up. Pilot should remain lit. If it goes out repeat
steps 3 through 8.
 If knob does not pop up when released. Stop and im-
mediately call your service technician or gas supplier.
 If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician or
gas supplier.
8. Push in gas control knob and turn counterclockwise
to "ON."
9. Flip up the faceplate door.
10.Turn on remote switch to ignite fire.
3. Push in gas control knob slightly and turn
to "Off". Do not force.
4. Flip up the faceplate door.
Tuscany
Gas Fireplace Insert
Model# 34DVI
clockwise
Page 13