Troubleshooting - Monster GreenPower HTS 1900G Owner's Manual

symptom
The PowerCenter is not receiving power .
RF Remote Control does not turn
outlets On/Off .

TRoUblesHooTInG

Possible Cause
The PowerCenter is not turned On .
Too many devices are connected,
causing an overload, tripping the
Thermal Circuit Breaker .
• Unit not plugged in.
• Wall Tap is too far away from unit.
Remedy
• Turn the PowerCenter switch on.
• Make sure the PowerCenter's AC power plug is plugged
into a properly grounded 120 volts (nominal) wall outlet .
• In some households, a wall switch may need to be
turned on to make the wall outlet active . Try turning
on the light switches located near the wall outlet .
• Press the PowerCenter Thermal Circuit Breaker button
in to reset . Please allow 10 minutes before attempting
to reset . If you reset too soon, the breaker will
prematurely sense power overload and not allow
the PowerCenter to operate .
• If the Circuit Breaker continues to trip, try moving one
or more components to another PowerCenter . You may
be drawing too much current through one PowerCenter .
• Plug in unit.
• Operate 50ft of unit. Obstacles such as walls, doors,
and metal cabinets may interfere with RF signal .
23