Additional Troubleshooting - Monster PowerNet 200 Instructions And Warranty Information

ADDITIonAL TrouBLesHooTIng

If your HomePlug
other, check the following:
· T ry power cycling the unit by unplugging it from the wall for 10 seconds
and plugging it in again.
· Use a pin and hold the Reset Button down for two seconds on each unit
you are trying to connect. The PowerNet device lights will flash, the units
will reset and attempt to link using default factory settings.
· Try plugging the PowerNet device into an adjacent plug.
· PowerNet devices work better when plugged directly into the wall outlet.
Connecting PowerNet devices to a power strip or surge protector may
degrade network performance or completely stop network signals.
· PowerNet devices should not be used on GFI protected outlets as some
outlets will filter out PowerNet signal.
· PowerNet devices should not be used in areas with excessive heat.
· Certain florescent or incandescent lights are noise sources
on the electrical and can cause performance degradation.
Do noT plug the
PowerNet 200 into a powerstrip
with surge protection. Doing
so may prohibit any PowerNet
communications
AV devices have difficulty communicating with each
®