Troubleshooting - Monster High Definition PowerCenter HDP1400G Owner's Manual

symptom
The PowerCenter is not receiving power .
RF Remote Control does not turn outlets On/Off .
16

TROUblesHOOTInG

Possible Cause
The PowerCenter is not turned On .
Too many devices are connected,
causing an overload, tripping
the Thermal Circuit Breaker .
• Battery is dead.
• Unit not plugged in.
• Remote control is too far away
from unit .
Remedy
• Turn the PowerCenter switch on.
• Make sure the PowerCenter's AC power plug is plugged into
a properly grounded 120 volts (nominal) wall outlet .
• In some households, a wall switch may need to be turned on
to make the wall outlet active . Try turning on the light switches
located near the wall outlet .
• Press the PowerCenter Thermal Circuit Breaker button in to
reset . Please allow 10 minutes before attempting to reset . If
you reset too soon, the breaker will prematurely sense power
overload and not allow the PowerCenter to operate .
• If the Circuit Breaker continues to trip, try moving one or more
components to another PowerCenter . You may be drawing too
much current through one PowerCenter .
• Replace battery.
• Plug in unit.
• Operate 30ft of unit.