Advertisement
Available languages
Available languages
Monster GreenPower
operation
™
Please read these instructions before connecting any equipment to the GreenPower RF Controlled (Switched) Outlets .
1 .
If you hook up a hard drive-based device such as a DVR, cable/satellite box, or video game console to a GreenPower
switched outlet, make sure that the device is not being read from or written to when you turn off the component
connected to the GreenPower Control outlet .
2 .
Important data and settings stored on hard drives (recorded TV shows, game saves, etc .) may be corrupted or deleted
if power is turned off while the hard drive is being read from or written to . To ensure against the possibility of data
loss or corruption, you should connect hard drive-based devices to unswitched outlets (or disable GreenPower using
the switch located at the end of the PowerCenter .) .
3 .
Monster assumes no responsibility for data loss, corruption or damage to hard drive-based devices connected
to PowerCenters with GreenPower automatic outlet switching .
4 .
Some components can take up to 10 minutes to switch to stand-by or sleep mode . If the Monster GreenPower
outlets on your PowerCenter do not turn off immediately, please wait approximately 10 minutes to allow the component
plugged into GreenPower Control outlet to switch to stand-by mode . Once this component is in stand-by mode, the
GreenPower switched outlets will turn off, eliminating stand-by energy waste by that component .
16
HooK-UP GUIDe
switched
™
Advertisement
Chapters
