Table of Contents
Advertisement
24
Delete button
Clicking this button will cause the following confirmation message to appear
(Figure 6.3.3). To delete a recorder's registered information, proceed
by clicking OK. Alternatively, using the Cancel button will remove the confirmation
message, and registered information will not be altered.
Figure 6.3.3
6.4 Recorder list... Command
Clicking the Recorder list... command in the Network menu will open the Recorder list
window (Figures 6.3 and 6.4). Starting with the next session, the Recorder list
window will automatically be displayed when a registered recorder is present.
Figure 6.4 Recorder list window (abbreviated)
Connect button
Connection to a selected recorder (indicated on the list through inverted coloring) can
be established by clicking this button. If, while connected, this button is used
again to select a different recorder, connection to a second recorder will
be made. In this case, connection to the first unit will be terminated.
Multiple computers cannot connect to the same recorder at the same time.
Disconnect button
Clicking this button will terminate the connection to the recorder currently in
communication with the PC. This function does not
work when there is no connected recorder present.
Details checkbox
Adding a check to this box will open the full version of the Recorder list window, which
includes the IP address and memo columns (Figure 6.3).
Advertisement
Table of Contents
