Mitsubishi DX-PC3 Instruction Manual page 11

11
Live
Acquires the newest image from the operation camera during communication
mode operation.
Renew Info
Acquires the newest information regarding alarm, camera operation and
other factors during communication mode operation. (Information
is automatically renewed approximately every 3 minutes even if this button
is not pressed.)
Position slider
Appears when SCSI-connected devices are played back. (This slider does not appear
when
starting this software.) By dragging the mouse on the slider, the playback image is mo
ved to the designated position of the medium. This slider
is corresponding to the block number of the medium but not to the time.
1 – 16
Specifies a camera for single-camera display. For clicking multiple buttons, Press Ctrl
and click on desired camera's number(s) (1 – 16) at
same time. Clicking multiple buttons will initiate sequential
display. During live communication (i.e., when
acquiring new images via the communication mode), only active cameras can
be selected; the buttons for inactive cameras will not respond. Buttons for
cameras currently recording are displayed in red. Furthermore, display can
be shifted to full-screen sequential display by canceling all selections.
2 x 2
Shifts display into 4-camera mode. Repeated clicks will cycle display as follows: 4a ->
4b -> 4c -> 4d -> 4a...
The initial settings for 4a – 4d are, from the top left field to the right: 1 – 4, 5 – 8, 9 – 12,
13 – 16.
3 x 3
Shifts display into 9-camera mode. Repeated clicks will cycle display as follows: 9a ->
9b -> 9a...
The initial settings for 9a – 9b are, from the top left field to the right: 1 – 9, 1 + 2 + 10 –
16.
4 x 4
Shifts display into 16-camera mode. The initial
settings are, from the top left field to the bottom right: 1 – 16.