Mitsubishi DX-PC3 Instruction Manual page 23

23
IP-address: field
The IP address of the recorder to be registered is entered in this field. As DX-PC3
uses this information to establish connections with recorders, it must be entered
correctly to ensure normal operation. In addition, duplicate IP addresses will not
be accepted.
Memo: field
Comments for the recorder to be registered can be entered in this field. Up to 40
characters can be entered, although the default display will only show up to 30
characters. (This field is not a mandatory setting.)
OK button
Enters the information of the above fields in the Registered Terminals list.
Cancel button
Cancels the operation of regiatering/adding a terminal.
6.3.2 Connect/Disconnect commands
Connections to registered recorders can be made using the Recorder list
window (Figures 6.3 and 6.4). Connections to recorders that are currently recording can
also be made.
Connect button
Please refer to Section 6.4 (Recorder list Command).
Disconnect button
Please refer to Section 6.4 (Recorder list Command).
Details checkbox
Removing the check from this box hides the IP address and memo columns,
converting the Recorder list window to its abbreviated version
(Figure 6.4). In the abbreviated window, the Add, Edit, and Delete buttons are also not
included.
6.3.3 Edit/Delete commands
Saved settings can be edited and registered recorders can
be removed via the Recorder list window (detailed version, Figure 6.3).
Edit button
Click a selected recorder on the list to access that recorder's Property box and
change its information. These changes will be reflected in the Recorder list
when the OK button is clicked. Using the Cancel button will
erase the changes made in the Property box, and these alterations will not be put
into effect.