Table of Contents
Advertisement
The procedure for recharging an optional battery pack is the same as the
standard battery.
Initializing the Battery Pack
Before using the battery pack for the first time, be sure to initialize it. Initialization
includes discharging and fully recharging twice.
1.
Make sure the battery pack is installed.
2.
Turn on the notebook.
3.
When the message <F2> to enter System Configuration Utility appears, press
F2 to open the System Configuration Utility.
4.
Disconnect the AC adapter, and leave the notebook until the battery is
completely discharged and the system shuts down automatically.
Connect the notebook to the AC adapter and fully charge the battery pack.
5.
6.
Repeat the above steps 2-5.
0
If you connect the notebook to wall outlet while discharging the
l
battery, the initialization is cancelled.
.
You cannot initialize two battery packs at the same time.
l
Charging the Battery
1.
Turn off the notebook.
2.
Connect the AC adapter to the notebook.
Wait until the battery is fully charged. While the battery is being charged, the
3.
battery charge indicator lights orange.
4.
When the battery is fully charged, the battery charge indicator lights green.
The charging time may vary according to the status of the notebook.
0 1
As a pre-caution, under long hours of operation, the notebook will stop
charging the battery automatically when
cause the battery charge indicator to go o
3-2
too hot. This wilt a&-,
When the temperature is low '
Advertisement
Table of Contents
