Advertisement
To connect exhaust duct
;rFeugh the right or left
-
1.
Remove
access
panel
by releasing
two locking
clips with a small, flat-
blade
screwdriver.
The clips are
located
four inches in from each
side
of the access
panel.
Personal Injury Hazard
Wear gloves to protect hands from
sharp edges that may be present.
Failure to do so may result In
personal InJury.
2. Remove
the duct tape from the
internal
exhaust
duct and the straight
duct.
3. Remove
the screw from the duct
clip that attaches
the straight duct to
the back of the cabinet.
Depress the
clip to remove
the straight
duct using
a twisting motion
through
the rear
exhaust
opening.
4. Reach through
the rear exhaust
opening
and depress center
of tabs
on the plastic opening
cover on the
side you want to exhaust
through.
Remove
the cover.
5
plain
end
90" elbow
5. Attach
a three- or four-section
elbow
to the straight duct using duct
tape.
90"
elbow
.
6. Insert elbow
end of duct pieces
through
the side opening.
Reach
through
the access
panel opening
and attach
elbow
to the internal
exhaust
duct. Check
the length of
straight duct extending
out the side
of the cabinet.
If duct extends
too far
to make the exhaust
duct
connection,
mark a line around
the
straight duct one inch out from the
cabinet.
Remove
the duct and elbow
and cut the straight
pipe to the
length
needed.
Reinsert the duct
pieces.
Use duct tape to connect
the
elbow
to the internal
exhaust
duct.
7. Insert the plastic cover into the
rear exhaust
opening.
8.
Replace
the access
panels.
9. Use duct tape to seal all Jolnts.
To connect exhaust duct
through the bottom of the
dryer -
Note: You must use a three-section
elbow
to connect
exhaust
duct
through
the bottom
of the dryer.
1.
Check that the legs extend
one
inch from the bottom
of the dryer.
2. Remove
the access panel
by
releasing
the two locking
clips with a
small, flat-blade
screwdriver.
The clips
are located
four inches in from each
side of the access
panel.
Lift access
panel off the bottom
clips and set
aside.
Page 7
Advertisement
