Table of Contents
Advertisement
Flying Saw with SIMOTION
5.2.3
Machine parameter settings
The standard application allows the following parameters to be adapted:
Machine geometry
•
Distance to sensor
Distance between the flying saw axis and the sensor of the material and
print mark detection
•
StartPosition
Position from which the flying saw starts motion to achieve synchronism
(with the material web)
•
StartSyncPosition
Position at which the flying saw is synchronized, start of the
synchronous traversing range
•
EndSyncPosition
End of the synchronous traversing range
•
EndPosition
Maximum traversing range of the flying saw
Flying Saw Axis Accelerations
•
Cut
Acceleration value for synchronization
•
Back
Acceleration value for return motion
•
Gap
Acceleration value for creating a "gap".
Creating a "gap"
•
GapVelocity
Additional velocity in order to create a gap between the material and the
cut piece
V 1.4
Section B: The application example as demonstration
O
t
Release 06/06/08
t l f th
li
ti
A4027118-A0414
system
l
51/107
Advertisement
Table of Contents
