Table of Contents
Advertisement
38
Note.
Hardware platform, operating system, and host
adapter variations can limit access to the full capac-
ity of this and other high capacity drives. Refer to
your system, host adapter, or drive utility documen-
tation for detailed instructions.
DOS, Windows 3.1, Windows 95, and Windows 98
System preparation
a.
Turn your computer on. As your computer starts up,
watch the screen for a message describing how to run
the system setup program (sometimes called BIOS or
CMOS setup). This is usually done by pressing a spe-
cial key, such as
See your computer manual for details. Press the appro-
priate key to run the system setup program.
b.
Set the drive type in your BIOS or CMOS setup to
"Zero," None," or "No hard drive installed" and then
save and exit from your setup program.
Drive partitioning
Partitioning a hard drive divides it into sections (partitions)
that act as separate logical drives (labeled C, D, E, et.). To
partition your new drive:
a.
Insert a bootable DOS diskette into your diskette drive-
and restart your computer.
b.
Insert a DOS program diskette that contains the
fdisk.exe and format.com programs into your diskette
drive. At the
c.
If you have two hard drives installed, the fdisk menu
displays five options. Option five allows you to select
Barracuda 50 Installation Guide, Rev. A
DELETE
prompt, type fdisk and press
A:
,
, or
ESC
F1
during startup.
.
ENTER
Advertisement
Table of Contents
