Seagate BARRACUDA 50 Installation Manual page 31

Table of Contents

Advertisement

Barracuda 50 Installation Guide, Rev. A
Additional connector on ST150176LW drives
ST150176LW drives have a connector located between the
SCSI I/O connector and the DC power connector to allow you to
set the SCSI ID and connect LEDs from the back of the drive.
You are not required to use this connector, but it's available if you
want to use it. Refer to Figure 11 for pin assignments.
SCSI I/O Connector
*
Figure 11. Alternate SCSI ID select and LED connection
68 Pin
J1
Pin 1
Pin 12
SCSI Address A0
SCSI Address A1
SCSI Address A2
SCSI Address A3
No connection
+5V
Fault LED*
Vendor Unique*
Reserved
Activity LED*
Ground
These pins are driven low for
250 ms after PWR ON or
RESET to allow jumper
selectable SCSI ID as shown
to the right.
J5/J1A [2][4]
4P
SCSI ID = 0
J1A Pin 1
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
Pin 1
3P
2P
1P
J1-DC Power
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

St150176lwSt150176lc

Table of Contents