Scsi Termination - Seagate Medalist Pro 2160N Installation Manual

Medalist Pro 2160N, Rev. B

SCSI termination

SCSI Host Adapter
Internal SCSI device
Internal SCSI device
Figure 2. Termination for internal SCSI devices
Chains of SCSI devices must be terminated at each end of the
cable.
The figure above shows two internal hard drives with the termi-
nation enabled for the SCSI host adapter and the last device on
the cable.
If your new drive is the last device on the SCSI cable, you must
enable termination. Active termination is enabled when there are
no jumpers on pins 11 and 12 of the options jumper block. This
is the default setting.
If your drive is not the last device on the SCSI cable, SCSI termi-
nation must be disabled by placing a jumper on pins 11 and 12.
5
Terminate
Terminate