Schumacher Electric SC-600A Owner's Manual page 6

10. CONTROL PANEL
Digital Display
The Digital Display gives a digital indication of % of charge or voltage, depending on the
Display Mode chosen.
Display Mode Button
Use this button to set the function of the Digital Display to one of the following:
• Battery %
connected to the charger battery clamps.
• Voltage – The Digital Display shows the voltage at the charger battery clamps in DC volts.
Battery Size/Charge Rate Button
Use this button to select the correct battery size/charge rate to one of the following:
• Small Charge Rate
used in garden tractors, snow mobiles and motorcycles.
• Medium Charge Rate
batteries. Not intended for industrial applications.
• Large Charge Rate
Not intended for industrial applications.
Battery Type Button
Use this button to set the type of battery to be charged.
• 6V
• 12V
• Regular (Standard)
• AGM
• GEL
11. OPERATING INSTRUCTIONS
assembly instructions before it is used.
Charging
1.
Ensure that all of the charger components are in place and in good working
condition, including the plastic boots on the battery clips.
2. Connect the battery following the precautions listed in Sections 6 and 7.
3. Connect the AC power following the precautions listed in Section 8.
4. Select the appropriate settings for your battery.
NOTE: This charger is equipped with an auto-start feature. It will not supply current to
the battery clips until a battery is properly connected. Unlike traditional chargers, the
clips will not spark if touched together.
Battery Connection Indicator
If the charger does not detect a properly connected battery, the CONNECTED (red) LED
will not light. Charging will not begin if the CONNECTED (red) LED is not on.
Automatic Charging Mode
When an automatic charge is performed, the charger switches to the maintain mode
(see below) automatically after the battery is charged.
Aborted Charge
Models SC-600A and SC-1000A: If charging can not be completed normally, charging
will abort. When charging aborts, the charger's output is shut off and the CONNECTED
(red) LED will blink. In that state, the charger ignores all buttons. To reset after an
aborted charge, unplug the charger from the AC outlet, wait a few moments and plug it
back in.
Aborted Charge
Models SC-1200A, SSC-1000A and SSC-1500A: If charging can not be completed
normally, charging will abort. When charging aborts, the charger's output is shut off, all
of the LEDs are turned off and the digital display will show bad bat. In that state, the
charger ignores all buttons. To reset after an aborted charge, unplug the charger from
the AC outlet, wait a few moments and plug it back in.
– The Digital Display shows an estimated charge percent of the battery
– Intended for charging small batteries such as those commonly
– Use for charging automotive, marine and deep-cycle
– Use for charging automotive, marine and light truck batteries.
This battery charger must be properly assembled in accordance with the
5
• •