Troubleshooting Sbc Express - Efficient Networks 5260MC02A Installation Manual

APPENDIX D

Troubleshooting SBC Express

Please refer to this list if you are having problems using SBC Express or if you receive an error
message. If after troubleshooting, you are still having problems, then you should contact the
numbers listed in Appendix A.
Step Problem
Minimum SBC Express verifies minimum requirements on
Resources several resources including hard drive space, RAM,
operating system level, and processor speed and
family.
If any of these resources are under the required value,
an error will display describing which resource did not
meet the requirement.
Installing When installing Network Interface Cards the
Network installation process may ask for the original installation
Interface Card disk.
Incompatible This scenario can occur when a machine had a
Adapter previous NIC or Network Adapter installed, but the
physical device is missing or was misconfigured.
This scenario can occur if Client for Microsoft
Missing Internet
Networks is not installed with the TCP/IP protocol or
Protocol
if the NIC is installed without binding TCP/IP to the
NIC.
Disabled This scenario can occur when a NIC is present in the
Network Adapter system, yet the adapter has been disabled.
Ping Test The Ping Test is usually accomplished within the
Configure TCP/IP step, where SBC Express pings the
default gateway. An explicit IP address can also be
used.
DNS Test The DNS Test will determine the currently defined
DNS servers, attempt to ping them, and upon a
successful ping, will resolve a specified hostname to an
IP address.
This concludes the DSL Equipment Installation Guide
Installation Guide for Customer Self-Install: Efficient Networks® 5260, Macintosh
©2001 SBC Advanced Solutions, Inc. All rights reserved.
Solution
Update your computer to the recommended
resource level.
You may have to provide an installation CD-
ROM for the installation of the drivers to be
successful.
Use the "Fix" button to launch the appropriate
system control panel along with context sensitive
help. The help provided will guide you through
the steps to disable or remove the adapter.
Use the "Fix" button to launch the appropriate
control panel and context sensitive help to guide
you in binding TCP/IP to the network adapter.
Use the "Fix" button with context sensitive help
to guide you through enabling the adapter.
Failure during this test can occur from invalid
network settings, the Ethernet cable not being
plugged in, the DSL modem not being in synch,
or if the specified IP address does not allow a
ping.
Make sure your Ethernet cable is plugged in and
powercycle your DSL modem. Use the "Retry"
button to try the test again.
This test can fail if the DNS server is invalid. If
you entered static IP information, ensure you
entered the DNS servers correctly.
Page 29