the HDD, overlapped data may be deleted. Be cautious when setting up the date and time.
⑥ Once the time is set up, move the cursor over BOOT APPLICATION, and then press ENT. The DVR
reboots and enters normal monitoring mode.
Caution
Appendix D) Factory Default Values
The SVR‐470 is released from the factory with default setting values as listed below. If you wish to reset
the product to the factory release mode while using the product, select
Miscellaneous
Default
[
] > [
.
values
[Note] The following settings do not change even if the DVR is reset to the factory default values.
Network Menu: Network, Client Access, E‐Mail
System Setup Menu: "NTP" value for "System Time" under the "Time" menu
Except for the settings listed above, all settings values are reset to the factory default.
Screen Setup
Main Menu
Title
Channel 1~4
Brightness
Contrast
Auto
Sequencing Intervals
Sequencing
V‐LOSS Skip
Display All
Clock
HDD Free Space
Screen Display
Record Mode
Channel Title
Event
Menu Contrast
When upgrading the firmware, the DVR may not be able to detect a USB stick
depending on the manufacturer. If that happens, please use one of the
recommended USB devices as listed below.
San Disk, Pretec, LG, Innotech C&C, or Transcend.
Modes "TEST MODE," "FACTORY DEFAULT," and "MAC CONFIGURATION" other
than those described above are reserved exclusively for the manufacturers
use; do not operate them.
Upon resetting the product, the settings are changed back to the default
].
Sub Menu
Appendix D) Factory Default Values
Yes
[
75
] >
at the
System Setup
]
[
Default Value/State
CH1 ~ 4
40
50
1 sec
Off
On
On
On
On
On
On
100%