Chapter 7. Recording & Event Setup; Record Setup; General Setup - Samsung SVR-470 User Manual

Chapter 7. Recording & Event Setup
7.1. Record Setup
Press the MENU button, and then select a tab using the left and right buttons. The Record sub menus
appear as shown in the picture below. Press the ENTER button, and select a sub menu using the left and
right buttons. Press ENTER again, and then change the settings of the menu by pressing the left and
right buttons.
7.1.1. General Setup
① IMAGE SIZE: Select a video size. The SVR‐470 supports two resolutions: 352x240 and 704x480.
② Selecting the largest size (704x480) improves the recorded image quality, but increases the file
size and decreases the frame rate. The monitoring screen can be recorded to the HDD. The
recordable capacity varies depending on the size of the HDDs.
③ REPEAT RECORD: Select to repeat the recording operation.
‐ [ON]: The unit keeps repeating the recording operation. If there is not enough space in the HDD,
it overwrites the oldest data with new recording data.
‐ [OFF]: If there is no longer enough space in the HDD, and then aborts the operation.
④ WARNING MESSAGE: Select a minimum % of free space left in the HDD to display an alert
message. Available ranges are from 1 to 20%, with 5 to 10% being generally recommended.
⑤ WARNING BEEP: Select ON or OFF to play an alert buzzer when the free space in the HDD reaches
the previously defined %.
43

7.1. Record Setup