Reset Station Passcodes To Default; Program Station Names - Samsung OFFICESERV 100 Series System Administration & Special Features Manual

Failure to enter the time using the 24 hour clock will cause the date to change at
12:00 P.M. Open customer programming and follow the instructions below.
ACTION
1. Press TRSF and then dial 505
Display shows
2. Enter the new time and date using
the above format
3. Verify the time and date and reenter
them if necessary
4. Press TRSF to store and exit
programming OR press SPK to store
and advance to the next program
If you have entered invalid data, you will receive an [ INVALID ENTRY ] message for
three seconds. Reenter the correct date and time. If the information you entered is
incorrect, repeat the procedure.
RESET STATION PASSCODES
TO DEFAULT
Individual keyset users can set or change their own individual passcodes. These
passcodes are used to lock and unlock keysets, override toll restriction and access
the DISA feature. At times, it may be necessary for the system administrator to
reset a station's passcode to default "1234."This program cannot be used to display
passcodes, only to reset them.
PROGRAM KEYS
UP & DOWN - Select the extension number.
HOLD - Press to reset the passcode.
Open customer programming and follow the instructions below.
ACTION
1. Press TRSF and then dial 101
Display shows
DISPLAY
OLD:6010184:0047
NEW:WMMDDYY:HHMM
OLD:6010184:0047
NEW:3020994:1445
OLD:3020994:1445
NEW:WMMDDYY:HHMM
DISPLAY
[201] PASSCODE
PASSCODE:,,,,
12
2. Dial the station number OR use the
UP and DOWN keys to scroll through
the keyset numbers and press the
right soft key to move the cursor right
3. Press HOLD to reset the passcode
4. Press the right soft key to return to
step 2 OR press TRSF to store and exit
programming OR press SPK to
store and advance to the next program
DEFAULT DATA: ALL STATION PASSCODES = 1234

PROGRAM STATION NAMES

This program is used to assign a character name or identification for each exten-
sion. You may assign a name of 11 characters long.
PROGRAM KEYS
UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
HOLD - Press to clear entry.
Open customer programming and follow the instructions below.
ACTION
1. Press TRSF and then dial 104
Display shows
2. Dial station number (e.g., 205)
OR press UP or DOWN to select the
station and press the right soft key to
move the cursor
3. Enter the station name using the
procedure described on the next page
and press the right soft key to return to
step 2
13
[205] PASSCODE
PASSCODE:,,,,
[205] PASSCODE
PASSCODE : 1234
DISPLAY
[201] STN NAME
[205] STN NAME
[205] STN NAME
SAM SMITH