Fisher-Price B8865 Instructions Manual page 8

Base
Wire
3
• Position the seat back tube so that it bends backward.
• Fit the seat back tube completely onto the base wires. Make sure the hole
in each end of the seat back tube aligns with the hole in each base wire.
• Fit a retainer (rounded side inward) to one end of the seat back tube.
• Insert a screw through the outside hole in the seat back tube and into
the retainer.
• While holding the retainer in place, tighten the screw with a Phillips screw-
driver. Do not over-tighten.
• Repeat this procedure to secure the other side of the seat back tube to the
base assembly using the remaining retainer and screw.
Assembly
Retainers
8
Seat Back
Tube Bends
Backward
Base
Wire