0114: Guitar Amp Simulator - Roland DP990F Implementation

● 0107: Speaker Simulator
Simulates the speaker type and mic settings used to record the speaker sound.
No Parameter Value
1 Speaker Type #1 0-15
2 Mic Setting 0-2
3 Mic Level 0-127
4 Direct Level 0-127
5 Level #2 0-127
Specifications of each Speaker Type
The speaker column indicates the diameter of each speaker unit (in inches) and
the number of units.
Type Cabinet
Small 1 Small open-back enclosure
Small 2 Small open-back enclosure
Middle Open back enclosure
JC-120 Open back enclosure
Built-In 1 Open back enclosure
Built-In 2 Open back enclosure
Built-In 3 Open back enclosure
Built-In 4 Open back enclosure
Built-In 5 Open back enclosure
BG Stack 1 Sealed enclosure
BG Stack 2 Large sealed enclosure
MS Stack 1 Large sealed enclosure
MS Stack 2 Large sealed enclosure
Metal Stack Large double stack
2-Stack Large double stack
3-Stack Large triple stack
● 0114: Guitar Amp Simulator
This is an effect that simulates the sound of a guitar amplifier.
No Parameter Value
1 Pre Amp Sw 0-1
2 Pre Amp Type #1 0-13
3 Pre Amp Volume 0-127
4 Pre Amp Master 0-127
5 Pre Amp Gain 0-2
6 Pre Amp Bass 0-127
7 Pre Amp Middle 0-127
8 Pre Amp Treble 0-127
9 Pre Amp Presence 0-127
Description
(See the table.) Type of speaker
Adjusts the location of the mic that
is recording the sound of the
speaker.
1, 2, 3
This can be adjusted in three steps,
with the mic becoming more
distant in the order of 1, 2, and 3.
0-127 Volume of the microphone
0-127 Volume of the direct sound
0-127 Output Level
Speaker Microphone
10 Dynamic
10 Dynamic
12 x 1 Dynamic
12 x 2 Dynamic
12 x 2 Dynamic
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 4 Condenser
12 x 4 Condenser
12 x 4 Condenser
12 x 4 Condenser
12 x 4 Condenser
Description
Off, On Turns the amp switch on/off.
JC-120,
Clean Twin,
MATCH Drive,
BG Lead,
MS1959I,
MS1959II,
MS1959I+II,
Type of guitar amp
SLDN Lead,
Metal 5150,
Metal Lead,
OD-1,
OD-2 Turbo,
Distortion,
Fuzz
Volume and amount of distortion of
0-127
the amp
0-127 Volume of the entire pre-amp
Low, Middle,
Amount of pre-amp distortion
High
Tone of the bass/mid/treble
0-127
frequency range
Middle cannot be set if "MATCH
0-127
Drive" is selected as the Pre Amp
0-127
Type.
0-127 (MATCH Tone for the ultra-high frequency
Drive: -127-0) range
10 Pre Amp Bright 0-1
11 Speaker Sw 0-1
12 Speaker Type #2 0-15
13 Mic Setting 0-2
14 Mic Level 0-127
15 Direct Level 0-127
16 Pan 0-127
17 Level 0-127
Specifications of each Speaker Type
The speaker column indicates the diameter of each speaker unit (in inches) and
the number of units.
Type Cabinet
Small 1 Small open-back enclosure
Small 2 Small open-back enclosure
Middle Open back enclosure
JC-120 Open back enclosure
Built-In 1 Open back enclosure
Built-In 2 Open back enclosure
Built-In 3 Open back enclosure
Built-In 4 Open back enclosure
Built-In 5 Open back enclosure
BG Stack 1 Sealed enclosure
BG Stack 2 Large sealed enclosure
MS Stack 1 Large sealed enclosure
MS Stack 2 Large sealed enclosure
Metal Stack Large double stack
2-Stack Large double stack
3-Stack Large triple stack
19
Turning this "On" produces a
sharper and brighter sound.
Off, On This parameter applies to the
"JC-120," "Clean Twin," and "BG
Lead" Pre Amp Types.
Determines whether the signal
Off, On passes through the speaker (ON),
or not (OFF).
(See the table.) Type of speaker
Adjusts the location of the mic
that's capturing the sound of the
speaker.
1, 2, 3 This can be adjusted in three steps,
from 1 to 3, with the mic becoming
more distant as the value
ncreases.
0-127 Volume of the microphone
0-127 Volume of the direct sound
L64 - 63R Stereo location of the output
0-127 Output level
Speaker Microphone
10 Dynamic
10 Dynamic
12 x 1 Dynamic
12 x 2 Dynamic
12 x 2 Dynamic
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 2 Condenser
12 x 4 Condenser
12 x 4 Condenser
12 x 4 Condenser
12 x 4 Condenser
12 x 4 Condenser