Unpacking; Contents Of Shipping Carton; Assembly - Jet AFS-2000 Operating Instructions And Parts Manual

Unpacking

Contents of Shipping Carton

1 Air Filtration Unit
1 Remote Control
2 AAA Batteries
4 Eye Bolts, Washers and Hex Nuts
1 Owner's Manual (not shown)
1 Warranty Card (not shown)
Tools Required for Assembly
10 mm Wrench
• The air filtration unit does not require muc h

assembly.

You
consideration how and where you will place
this unit.
•
This unit will work best if it is located away
from corners, and heating/cooling vents.
•
If using on sawhorses the air filtration unit
should be clamped in place.
•
This unit is specifically designed to circulate
and filter non-metallic
generated throughout the work area.
Assembly
Mounts must be anchored to
building structure, which will support a
minimum of 220 pounds. Never mount to
surfaces such as dry wall or false ceiling
grids, etc.
1. Remove all packing from inside of the unit
by opening the side panel.
2. Make sure the hex nut (A, Figure 2) is
threaded all the way up the eyebolt (B,
Figure 2).
3. Place a flat washer (C, Figure 2) on the eye
bolt. Screw the eye bolt into the cabinet and
tighten hex nut against the cabinet top. You
will need to hold the eyebolt so it does not
spin while tightening the hex nut.
4. Repeat steps for remaining three eyebolts.
Note: Make sure chain and ceiling hooks are
properly rated for hanging this unit. Hang unit
with a seven-foot clearance from the floor.
should take into
dust, which is
Figure 1
Figure 2
7