Advertisement
Quick Links
•
Read and understand all warnings and operating instructions before attempting to use the beam
clamp.
•
Beam clamps are designed and intended for use on "I" and "H" beams having an installed rated
value of the beam clamp.
•
NEVER install a beam clamp on a beam that has not been rated or tested for attachment of lifting
devices.
•
Beam clamp must be fully tightened and fully engage beam before use.
•
Beam clamps are designed for vertical lifts only. DO NOT use for side or angle pulls or lifts.
•
Always replace worn, damaged or missing labels.
Failure to comply with these warnings may result in personal injury and/or property damage.
JET
WMH Tool Group
www.jettools.com
OWNER'S MANUAL
JBC Series Beam Clamps
WARNING
P.O. BOX 1349
Auburn, WA 98071-1349
e-mail jet@wmhtoolgroup.com
Phone: 253-351-6000
Fax: 1-800-274-6840
M-252710
6/02
Advertisement
Related Manuals for Jet JBC Series
Summary of Contents for Jet JBC Series
- Page 1 OWNER’S MANUAL JBC Series Beam Clamps WARNING • Read and understand all warnings and operating instructions before attempting to use the beam clamp. • Beam clamps are designed and intended for use on “I” and “H” beams having an installed rated value of the beam clamp.
- Page 2 Parts List for JBC Series Beam Clamps Index Part Description Size Qty. 1..JBC1-1......Clamp (1-Ton) ..................1 ....JBC2-1......Clamp (2-Ton) ..................1 ....JBC3-1......Clamp (3-Ton) ..................1 ....JBC5-1......Clamp (5-Ton) ..................1 2..JBC1-2......Shaft Housing Short (1-Ton) ...............1 ....JBC2-2......Shaft Housing Short (2-Ton) ...............1 ....JBC3-2......