Buttonhole - Janome Sewing Machine Instruction Book

1
BH
4
3 1
2
1 2
(C)
(B)
4
3
7
2
3
(A)
6
5

Buttonhole

Pattern selector:
1
Presser foot:
2
Thread tension:
3
* Make a test buttonhole on a sample duplicating the
fabric, interfacing and seams of the actual garment.
* Place the button on the fabric sample and mark the
top and bottom to determine the position of buttonhole.
* Use interfacing on stretch fabrics.
Carefully mark buttonhole length on fabric.
z
Place the fabric under the foot with the buttonhole
marking running toward you.
Move the slider (A) toward you so that the top mark (C)
x
on the slider meets the start mark (B). Line up the
markings on the foot with the top mark on the fabric.
Note:
The scale on the slider is engraved in centimeters.
c
Set the pattern selector dial at "
Sew forward until you reach the front marking of your
buttonhole.
Stop sewing at a left stitch.
v
Set the pattern selector dial at "
Sew 5 stitches. Stop sewing at a right stitch.
Set the pattern selector dial at "
b
Sew until you reach the back marking of the buttonhole.
Stop sewing at a right stitch.
n
Set the pattern selector dial at "
Sew a few bartacks and raise the needle from the fabric.
Set the pattern selector dial at a straight stitch.
Sew a few locking stitches.
m Remove the fabric from the machine and cut the sewing
thread. Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
36
(BH)
Sliding buttonhole foot
1–5
".
".
".
".