Sewing On Buttons - Janome Sewing Machine Instruction Book

1
1 2
3
4 5
2
3
4

Sewing on Buttons

Pattern selector:
1
Presser foot:
2
Thread tension:
3
Feed dog:
4
z
Adjust the stitch width, and turn the handwheel to check
if the needle enters into each hole in the button.
Lower the foot to hold the button in place.
x
The holes in the button should align with the slot of
the foot.
A pin can be placed on the foot to form a shank.
c
Make sure to check if the needle enters into both holes
in the button.
Sew about 10 stitches and cut the needle and bobbin
threads, leaving a 20 cm (8") tail.
v
Bring the needle threads between the button and fabric
through the holes in the button.
b Pull the needle threads to pick bobbin threads up to
the right side of the fabric.
Wind the threads to form a shank and tie them together.
* Raise the feed dog after sewing.
34
C1-C3
Zigzag foot
1–3
Dropped