Troubleshooting - Janome COVER PRO 900CP Instruction Book

Troubleshooting

Problem
Needle thread
breaks.
Needle bends or
breaks.
Skipped stitches
Seam puckering
Machine does not
operate.
Cause
1. The machine is not threaded correctly.
2. The thread tension is too tight.
3. The needle is bent or blunt.
4. The needle is not set correctly.
5. A wrong needle is used.
1. The needle is bent or blunt.
2. The needle is not set correctly.
3. The needle clamp screw is loose.
4. The fabric is forcedly pulled.
1. The needle is not set correctly.
2. The needle is bent or blunt.
3. The tension is out of balance.
4. The machine is not threaded correctly.
1. The tension is out of balance.
1. The machine is not connected to the power supply.
2. The foot control is not plugged in firmly.
22
Reference
See pages 10-14.
See pages 15, 16.
See page 8.
See page 8.
See page 8.
See page 8.
See page 8.
See page 8.
Do not pull the fabric.
See page 8.
See page 8.
See pages 15, 16.
See pages 10-14.
See pages 15, 16.
See page 4.
See page 4.