Troubleshooting - Janome JUNO E1015 Service Manual

PROBLEM
1. Skipping 1. Needle is not inserted
stitches properly.
2. Needle is bent or worn.
3. Incorrectly threaded
4. Needle or thread are
inappropriate for fabric being
sewn.
5. Sewing on stretch fabric
6. Inappropriate needle bar
height
7. Inappropriate needle to hook
timing
8. Inappropriate needle to hook
clearance
2. Fabric not 1. Incorrect feed dog height
moving
2. Thread on bottom side of
fabric is jammed up.
3. Feed dog teeth are worn.

TROUBLESHOOTING

CAUSE
1
REMEDY
Insert the needle properly.
Change the needle.
Rethread.
Use the recommended sewing
needle and thread.
Use A #11 blue tip needle.
See mechanical adjustment
" Needle bar height."
See mechanical adjustment
"Needle timing to shuttle."
See mechanical adjustment
"Clearance between needle and
hook."
See mechanical adjustment
"Feed dog height."
Make sure to bring both needle
and bobbin thread under the foot
when starting sewing.
Change the feed dog.
REFERENCE
P. 16
P. 17
P. 13, 14
P. 15