Table of Contents
Advertisement
Recovery
before query preparation.
SQL 2109
2109 Invalid Character error converting SQL statement from character
set from character set to character set to character set.
from character set
to character set
Cause
The character translation routines failed in the translation between character sets. The
most common problem is the supplied character string is not encoded in the character set
requested.
Effect
The operation fails.
Recovery
character string.
SQL 21 10
2110 Buffer Overrun error converting SQL statement from character set
from character set to character set to character set.
from character set
to character set
Cause
Not enough space was allocated to translate between the character sets.
Effect
The operation fails.
Recovery
SQL 2200
2200 DEFAULTS attribute attribute is read-only.
attribute
Cause
You attempted to change the DEFAULTS attribute, which is read-only.
Effect
The operation fails.
Recovery
SQL 2201
2201 SQL compilation return code is mxcmp non-zero exit code.
Cause
You invoked mxCompileUserModule on an application file that has an embedded
module definition. An SQL compilation of an embedded module definition resulted in an HP
Neoview compiler nonzero exit code, indicating a warning or error.
Effect
The operation fails.
Recovery
to the module source file and correct the offending source statement. Retry preprocessing,
translating, compiling, and SQL compiling the application file.
SQL 2202
2202 Application file is not an application (ELF or SQL) file.
84
Neoview Compiler Messages (2000 Through 2999)
This is an informational message. To prevent this warning, turn off query caching
may be any of the supported character sets. One of the "from" or
"to" character set is always UCS2.
may be any of the supported character sets. One of the "from" or
"to" character set is always UCS2.
Specify a different character set for either the input character string or the output
may be any of the supported character sets. One of the "from" or
"to" character set is always UCS2.
may be any of the supported character sets. One of the "from" or
"to" character set is always UCS2.
Contact your HP service provider about this problem.
is the DEFAULTS attribute.
None.
Review the Neoview compiler warning or error message. Trace the diagnostic back
Advertisement
Table of Contents
