Table of Contents
Advertisement
Error Number
0097
0098
0099
0100
0101
0102
0103
0104
0105
0106
0110
0111
0112
0113
0119
0120
0121
0122
0123
0124
0130
0131
0132
0133
0134
0135
0136
0137
0138
0139
0140
0148
0150
0151
0152
0153
0154
0155
388
File-System Errors
File-System Error Text
Transaction aborted by call to ABORTTRANSACTION.
Allocation of a Transaction Control Block failed because the local table is full, or the table on a
remote segment is full.
Process attempted to use features of a microcode option that is not installed on this segment.
Device is not ready or the controller is not operational.
The tape is write protected.
Printer paper out, bail open or end of ribbon.
Disk not ready due to power failure.
No response from printer.
Invalid printer vertical format unit buffer.
A buffered WRITE has failed; data in printer buffer was lost.
Only BREAK access is permitted.
Operation aborted because of BREAK.
READ or WRITEREAD preempted by operator message or too many user console messages.
DEFINE class or attributes are not valid for the attempted function.
Error code value was too large to fit into an 8-bit buffer; file-system error number is greater than
255.
Data parity error, or attempt to access a tape whose density is higher than the switch setting on
the tape drive.
Data overrun error, hardware problem.
Request aborted due to possible data loss caused by reset of circuit, bus sequence error; or Data
Access Manager process takeover.
Subdevice is busy.
A line reset is in progress, loss of data is possible.
Illegal disk address requested, or formatting error occurred.
Write-check error from disk; internal circuitry fault.
Seek incomplete from disk; cylinder address not reached after retry.
Access not ready on disk; cylinder address not reached.
Address compare error on disk.
Write-protect violation with disk write.
Disk unit ownership error (dual-port disk).
Controller buffer parity error.
Interrupt overrun; a device interrupted the processor before the software could respond.
Controller error; internal diagnostic failure.
Modem error (communication link not yet established, modem failure, momentary loss of carrier,
or disconnect).
Attempt to read unwritten data.
End-of-tape marker detected.
Runaway tape detected, or attempt to access a tape whose density is lower than the switch setting
on the tape drive.
Unusual end-tape unit went offline.
Tape drive power restored.
BOT detected during backspace files or backspace records.
Only nine-track magnetic tape allowed on this system.
Advertisement
Table of Contents
