Front Door Installation - Regency ULTIMATE U39-LP Owners & Installation Manual

7) Place the Left Top Log D)02-46 on the pin
on Log B)02-56 and on top of the cutout on
Log A)02-65.
D)02-46
B)02-56
C)02-44
Pin
8) Place Front Right Log E)02-45 on the two
pins as shown.
E)02-45
9) Place the lava rock in the area between the
left and right logs, leaving a space in the
middle for log (F) 02-47.
10) Place the notch in Center Log F)02-47 over
Log E)02-45 and across the cutout on Log
A)02-65.
F)02-47
Notch Cutout
Regency U39 ULTIMATE Direct Vent Freestanding Gas Stove
11) Position notch in Front Right Log G)02-48
on Log F)02-47 and push the bottom right
edge against the bracket on the burner
tray.
A)02-65
A)02-65
Notch
Cutout
E)02-45
Side View
The bottom right edge of Log G)02-48 must
sit snugly against the bracket
12) Test fire to ensure proper light off (make
sure flame flows smoothly from one end of
burner to the other. If there is any flame
hesitation, check that area for any block-
age of the burner port.
B)02-56
C)02-44
A)02-65
E)02-45
1) Open the two side panels.
G)02-48
2) Slide the door
E)02-45
3) Close the door.
G)02-48
4) The latches should already be at the proper
Bracket
A)02-65
5) Remove the blue plastic protective coating
6) Test the seal around the door by placing a
E)02-45
Note:
INSTALLATION
FRONT DOOR
INSTALLATION
(packaged separately)
onto the two
hinge pins mak-
s u r e t h e t w o
pieces are
flush together.
See diagram 1.
latch plate must be
centered around the
alignment pin. See dia-
gram 2. If the latch plate
interferes with the cor-
ner of the stove you
Diagram 1
may want to angle the
plate slightly so the door closes easier.
setting. If they are too hard or too easy to
close, you may want to adjust them by
loosening the latch catch. See diagram 3.
Diagram 2
from the glass.
piece of paper between the unit and the
door, close the door and try to pull the paper
out. If it slips out easily, then the door is not
properly sealed. Tighten or loosen the latch.
See diagram 3.
Diagram 3
The door latch may require ad-
justment as the door gasket mate-
rial compresses after a few fires
and after glass replacement. Turn
the latch catch inward or outward
to loosen or tighten.
i n g
The
25