Radio Shack 15-1990 Owner's Manual page 7

15-1990.fm Page 7 Tuesday, December 14, 1999 12:45 PM
3. Hold down until the red light blinks twice, then
P
enter the 4-digit code you wrote down in Step 1
using these keys:
Press
VOL +
VOL –
CH +
CH –
MUTE
For example, to replace a TV's remote control
(manufacturer's code 1432), press
down until the red light blinks twice, then press
P
, , , and
VOL + CH – CH +
When the red light blinks twice, the remote con-
trol has accepted the code.
Note: If the code you entered is invalid, the red
light blinks.
4. Point the remote control at your device and
press . Your device should turn off (or
POWER
on, if it was off).
If the remote does not operate your device, try
the other codes listed in "Manufacturers' Codes"
on Page 11 for your brand of TV, VCR, TV/VCR
combination, or cable converter.
5. Repeat Steps 2–4 for additional devices.
To Enter
This Number
1
2
3
4
5
, hold
TV
.
VOL –
7