System Controls - Generac Power Systems Mobile Power MMG130 Specifications

MMG130 Specifications Continued:
•
96 kW / 96 kVA – standby, single phase
•
90 kW / 90 kVA – prime, single phase
•
107 kW / 134 kVA – standby, three phase
•
98 kW / 122 kVA – prime, three phase

SYSTEM CONTROLS

•
Microprocessor-based controller
o Backlit, 128x64 pixel resolution display
o -40°F to 185°F operating
temperature range
o Thermostatically controlled LCD
heater
o Six LED indicators w/ lamp test
• Push buttons for easy operation
o Manual or Auto Start
o Engine Start or Stop
o Alarm Cancel & Fault Reset
o Scrolling Arrows for Diagnostic Information
o Alarm list – warnings / shutdowns are date & time stamped
Manufactured by Magnum Power Products LLC., a wholly owned subsidiary of Generac Power Systems, Inc.
♦ Alarm / Fault (Red)
♦ Ready / Manual (Red)
♦ Running (Green)
♦ Warning (Yellow)
♦ Ready / Auto (Green)
♦ Supplying Load (Green)
♦ System kW output display
♦ Line output & frequency display
♦ Engine diagnostic display
•
Oil pressure
•
Engine temperature
•
Fuel level
•
Battery
♦ System hours
•
Running hours
•
kW hours
• Time to service
♦ Fuel level: warning – 15%; shutdown – 5%
♦ Overspeed protection: shutdown – 115%
♦ Oil pressure: warning – 25 psi; shutdown – 20 psi
♦ Coolant temperature: warning – 220°F; shutdown – 230°F
♦ Battery voltage: over – 15VDC; under – 11VDC
♦ Generator over voltage: warning – 110%; shutdown – 111%
♦ Generator under voltage: warning – 87%; shutdown – 86%
♦ Generator over frequency: warning – 105%; shutdown – 110%
♦ Generator under frequency: warning – 95%; shutdown – 90%
♦ Over current shutdown
Phone: 800-926-9768 Fax: 920-361-2214 www.m-p-llc.com
Page 2 of 5
06/12