Terminal Setup
RF Monitor
Select
RF Monitor is an "Over The Air" diagnostic tool. It is used to collect diagnostic trace
information from RF terminals running PowerNet Twin Client software.
It runs on a Windows PC and will send a command to the RF terminal to start tracing.
The terminal, when it receives this command, will start sending the trace information
over the RF link to the PC that issued the command. This will be written to a file on this
PC that can be sent to us for analysis.
Click on
Choosing
Terminal IP Address and Terminal IP Port, and click on
2-36
Tools
from the
File
to Select Terminal or to Exit
Select Terminal
allows you to view a log of the terminal's activity. Enter the
menu.
.
OK
Supported Equipment Manual
.
•
May, 2006