Table of Contents
Advertisement
page 10
Diagram 5
Removing hardware from the T-knob
assembly.
Leather pads
Rod
Flat washer
Thrust bearing
Flat washer
T-knob
Diagram 6
Sliding the rod through the right
handrail mount.
Smooth side of leather pad
Right handrail
Rod
Right handrail mount
Side rail mount
CAUTION: Make sure that the
micro-adjustment cable does
not loop around the rod or get
pinched between the handrail
mount and the side rail.
3.
Prepare the T-knob Assembly for Installation. (Diagram 5) Remove one
T-knob and its 2 flat washers and 1 thrust bearing (looks like a washer
with ball bearings) from one side of the rod. Take both leather pads off the
rod as shown in Diagram 5.
4.
Install the Handrails. (Diagrams 6, 7, and 8) Move to the right side of the
treadmill to install the right handrail. The right handrail has the micro-
adjustment cable running through it. See Diagram 6. Take the following
steps to mount the handrails:
a.
Have your assistant turn the handrail so that the mounting holes on
the handrail align with the side rail mounts. Slide the rod through the
right handrail mount. See Diagram 6.
b.
Pick up a leather pad. Notice that one side is smooth and the other
side is rough. Place the pad onto the rod so that the smooth side
faces the handrail mount. Slide the leather pad up against the
handrail mount.
Advertisement
Table of Contents
