Table of Contents
Advertisement
page 20
Configuring the M9.5sp Treadmill Default Settings
The M9.5sp treadmill lets you preset many of the answers to the standard
startup prompts. Configuring the default settings eliminates the time it takes to
answer all the startup prompts, letting you begin your workout sooner.
Precor has preset several of the default answers at the factory, as shown
below:
M9.5sp
Distance Mode?
Speed Mode?
Program Speed?
Use Pacer?
Use Warmup?
To preset answers to many of the prompts, take the following steps. While
following these steps, you can press the HELP key at anytime and an explana-
tion of your selection will scroll across the top of the display.
1. Locate the ON/OFF switch located at the front of the black hood. Turn ON
the treadmill. The prompt, "Press Enter to Begin" appears on the elec-
tronic console display.
2. Straddle the running belt with your feet firmly planted on the right and left
staging platforms. (Stand close enough to the electronic console so you
can extend your arms and touch the keys.)
3. Press the hidden key to access the Configuration and Custom Course
modes. The display briefly shows the odometer on your treadmill.
Note: The hidden key is located directly below the STOP key and to the
right of the INCLINE key. You can press this key only when the "Press
Enter to Begin" prompt appears.
4. At the "Set Configuration?" prompt, use
answer YES and configure the M9.5sp treadmill default settings.
5. At the "Distance Mode" prompt, select one of the following:
If you want...
To be asked this prompt at the
beginning of each session
Distance measured in Miles
Distance measured in Kilometers
6. At the "Speed Mode" prompt, select one:
If you want...
To be asked this prompt at the
beginning of each session
Speed measured in MPH
Speed measured in KPH
Configuration
Miles
Miles per hour
Constant
No pacer
No warmup
arrows on the left key to
Then...
Press ENTER
Press
Press
Then...
Press ENTER
Press
Press
Advertisement
Table of Contents
