Table of Contents
Advertisement
Diagram 2
Installing the Front Lift Bar assembly.
Flywheel
Running belt
Washer
Bolt
Side rail mount
Front lift bar
Height adjustment pin
Locking portion of pin
Elevation tube
Diagram 3
Locking handrail into upright position.
Micro adjustment knob
Handrail
Front lift bar
Side rail
T-knob
Frame plate
Height adjustment pin
Elevation tube
page 6
d.
Re-insert the bolts and washers as shown in Diagram 2. Tighten the
bolts securely using the hex key provided.
2.
Position the Handrail. (Diagram 3) Remove the T-knobs and washers
from the hardware kit and take the following steps to secure the handrail:
a.
Pull the handrail into an upright position. See Diagram 3.
Important: Perform the remaining steps on one side of the treadmill
at a time.
b.
Hold onto the handrail while you insert a T-knob and washer through
the handrail mount (one on each side of the treadmill). Repeat this
step for the opposite side.
c.
Align the T-knob with the hole in the side rail and tighten the T-knob
by turning it clockwise. Alternately tighten the T-knobs until both
washers are tight against the side rails.
3.
Adjust the incline of the treadmill and set the running belt to the proper
resistance level, by following the steps in Adjusting the Elevation Tube .
Advertisement
Table of Contents
