Connecting The Scansnap - Fujitsu ScanSnap S1300i Getting Started Manual

Connecting the ScanSnap

ATTENTION
Only one ScanSnap can be used by a computer at
a time.
Use only the cable supplied with the ScanSnap.
CAUTION
Do not use AC adapters other than the one supplied
with this ScanSnap. Doing so may cause damage to
the ScanSnap.
Manufacturer: LEI
Model No.: NU13-1072166-I3
1.
Select the power cable type according to
power source for the ScanSnap.
To use the ScanSnap at a fixed location
Use the power cable to connect to an AC outlet.
For details about the connection, refer to "Using
the Power Cable" (page 5) in Step 3.
AC
Adapter
To use the ScanSnap in a remote location with
your laptop computer or a place without AC
outlets available nearby
Use the USB bus power cable for power supply
from your computer.
For details about the connection, refer to "Using the
USB Bus Power Cable" (page 5) in Step 3.
2.
Remove the tape seal covering the USB
connector and power connector of the
ScanSnap.
3.
1. Connect the power cable
2. Connect the USB cable
AC Cable
1. Connect the USB bus power cable
USB Bus
Power Cable
2. Connect the USB cable
5
Connect cables to the ScanSnap.
ATTENTION
To power on the ScanSnap, the USB cable
and either of the power cables (power cable or
USB bus power cable) need to be connected.
When connecting to USB hub, make sure to
connect the ScanSnap to the USB hub which
is connected to a USB port of your computer.
Use a powered USB hub (with AC adapter).
If USB port or USB hub is USB 1.1, scanning
speed will slow down.
Connect the USB cable with the USB mark
facing up.
Using the Power Cable
connector of the ScanSnap and plug in the
AC outlet.
connector on the ScanSnap and the USB
port on your computer.
Using the USB Bus Power Cable
power connector on the ScanSnap and the
USB port on your computer.
connector on the ScanSnap and the USB
port on your computer.
to the power
to the USB
to the
to the USB