Fujitsu ScanSnap S1300i Getting Started Manual page 6

4.
Open the ADF paper chute (cover) of the
ScanSnap.
ADF Paper Chute
(Cover)
The ScanSnap is powered on and the [Scan]
button lights in blue.
ATTENTION
The bottom of the ScanSnap may become hot
when the ScanSnap is used, but this heat
does not affect operation or cause any
physical harm. However, be careful not to drop
the ScanSnap when carrying it.
When the ScanSnap is turned on and left
unused for 4 hours, it will turn itself off
automatically. To turn the ScanSnap back on,
perform one of the following operations:
- Press the [Scan] button
- Close the ADF paper chute (cover) and open
it again
The time until power-off can be changed. For
details, refer to the Operator's Guide.
[Scan] Button
6
5.
Check the ScanSnap Manager icon.
The ScanSnap Manager icon
bus powered connection) is displayed in the
menu that appears when you click
taskbar.
To have the ScanSnap Manager icon
for USB bus powered connection) always
displayed on the taskbar, drag the icon and
drop it onto the taskbar.
ATTENTION
If the ScanSnap Manager icon is
on and select [To establish connection] from
the menu. You can reference the appropriate
actions for connecting the scanner.
The ScanSnap Manager icon
bus powered connection) appears in the
Dock.
ATTENTION
If the ScanSnap Manager icon is
holding down the [control] key, click
select [To establish connection] from the menu.
You can reference the appropriate actions for
connecting the scanner.
( for USB
on the
(
, right-click
( for USB
, while
and then