9) BOTTOM TRAY
The door is swiftly opened and the
plastic cover located at the bottom of
the machine is taken out, by being
rotated in the downward direction
without using any tool. Afterwards
when this plastic cover is repositioned,
the similar procedure is applied but this
time by being rotated in the reverse
direction
While providing service to the components
located beneath the machine, the machine is
moved to a place other than the place of
installation.
For dismantling the tray, the machine is inclined
backwards with an angle of approximately 40˚.
2 screws holding the base and located
on the front side are removed and the
components beneath the machine are
accessed. Thus, it is possible to work
on all the components except for the
Water Inlet Valve, Clip Holder and the
Drain Hose.