Worx WG250 Instruction Manual page 10

IO
ply and the green light (13) will illuminate Jr.
Then, fully insert the battery pack into the char-
ger to make the connection and the red light
(14) will illuminate to show charging has start-
ed [_. A discharged battery at normal ambient
temperature will take approximately 1 hour to
reach full charge. Charging time may vary due
to variable ambient temperatures and battery
conditions. When charging is completed the
green light (13) will illuminate to indicate end of
charge (See D)_.
Note: green = power on,
red = chargi,g,
Bakery pack iase_ed + gree, |ight =
chargiag completed
The battery pack can then be removed for use
in your hedge trimmer.
The charger timer circuit and battery pack tem-
_ erature safety cut-out device prevent
overcharging of your battery pack.
Warning: After long usage the battery will be-
come hot, let the hot battery cool down for 1
hour before recharging.
5. TO REMOVE OR INSTALL BATTERY
PACK
Release the handle and rotate to the position
in (figE). Locate latches on side of battery pack
and depress both sides to release battery pack
from your hedge trimmer. Remove battery pack
from your hedge trimmer. After recharging in-
sert the battery pack into hedge trimmer's bat-
tery port. A simple push and slight pressure will
be sufficient. Check to see if the battery is fully
secured.
STARTING AND STOPPING
BEFORE STARTING YOUR HEDGE
TRIMMER
Remove blade sheath (10) (See F).
TO START YOUR HEDGE TRIMMER
Your trimmer is equipped with two switch
levers (2 & 4). Both switch levers need to be
pressed for the hedge trimmer to start. Depress
and hold the front switch lever (4) and press the
rear switch lever (2) (See G).
TO STOP YOUR HEDGE TRIMM|:R
Move hedge trimmer away from cutting area
before stopping.
To stop, release one of the switch levers (See H).
Warning: if any parts are missing,
damaged or broken, do not operate
your hedge trimmer until aJ| _mafjed
parts have been replaced or repaired.
EaiJure to do so couW result in serious
persona| injury°
DO NOT USE WITHOUT HANDLE AND
GUARD.
OPERATING TME HEDGE
TRIMMER
ADJUSTING THE FRONT HANDLE
POSiTiON
The f¥ont ha.die can he set in three
positions. Release the Ha.die CAM
Lever(G) to adjust the front ha.die to the
most comfortable position.
Then
close
CAM Lever(G) to lock it in that position
(See |) Caution: Ensure you suppo_ the
weight of the hedge trimmer before you
adjust the front handle.
HOW TO USE YOUR HEDGE TRIMMER
Note that the switch lever can be activated
on three sides, giving you many choices for
a comfortable grip. Before cutting an area,
inspect it first and remove any foreign objects
that could become thrown or entangled in the
blades. Always hold the trimmer with both
hands and with the blade away from you before
turning it on.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade (See J & K).
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
if the blade stalls, immediately stop the
trimmer. Release the two switch levels (2 & 4)
before attempting to clear jammed debris from
the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
CTC-WG250-M-060417Jndd 10 2006-4-20 14:53:30